Combined the new MAX32 MUSB implementation with the existing (TI) implementation to provide generic code base for working the MUSB DCD peripheral.
- Added abstraction calls for FIFO setup, EP registers, Ctrl registers and interrupt setup.
- Combined TM4C and MSP432E into a single header file.
- Created musb_max32.h, and removed the MAX32 specific C implementation.
- Updated MAX32 build system to use dcd_musb.c.
- Added MAX32 conditions for cdc_dual_ports example descriptors missed during first testing.
Fix handling of interrupt endpoints. i.e. no ZLPs.
Fix the assignation of endpoint types.
Add button support for MM900evx boards.
On board support do not block for UART input.
Correct USB FIFO use for setup data phases (OUT transfers). We cannot stop traffic on the control endpoint so we set a flag and pull data from host when tinyUSB requests it from the USB FIFO. Extend this for all endpoints although currently not required.
Rename all instances of ft90x which can apply to ft93x as ft9xx.
Add support for the cdc_dual_ports example for ft9xx.
Add LED pin definition for board LED in a simple to access place on the Bridgetek MM900EVx boards.
The SetLineCoding would fail as host would send the SETUP OUT phase before tinyUSB had setup a transaction for it. ft9xx port would ignore the transfer since there was no valid transaction setup for it. One SETUP data phase packet is cached now.
IAR generates warning Pe111 'statement is unreachable'. In a couple of
cases, replace return statements with TU_ATTR_FALLTHROUGH; because some
compilers apparently can't figure out that the return statements are
unreachable but do whinge about an imagined fall-through without them!
- remove "-Wno-stringop-overflow -Wno-array-bounds"
- skip -Wconversion for gcc 9 and prior
- suppress_tinyusb_warnings only when building with gcc 9 and below
* gcc 9.2.1 has some spurious -Wconversion warnings
* cmake 3.18 and above require set_target_properties to be added from the target directory (so added it to all examples)
* fixed a few warnings in a couple of examples
example implement tud_descriptor_device_qualifier_cb() and
tud_descriptor_other_speed_configuration_cb() on high speed device to
fully compliant to usbcv
- Examples should be CMake buildable from their own subdirectory; such a build will error out based on
matching .skip.MCU_xxx or a mismatched .only.MCU_
- It should be possible to build from a higher level and use .skip.MCU_ and .only.MCU_ to filter which
examples get built
- The intention is for the CMakeLists.txts in the examples to be non family specific and without MCU based IFs. I have
started this work, but am not really sure the state of the esp32 stuff; in any case the plan is to have
everything encapsulated in the FAMILY/family.cmake
- pico_examples now just includes examples/device/CMakeLists.txt and examples/host/CMakeLists.txt directly, as they
also build correctly when included from there.
Note that .skip.MCU_ for esp32 in the directories it wasn't previously avaiable has not been added, as the .skip is common to the regular Makefile builds also. It isn't clear whether these examples should build for esp32, but if not .skip should be added.
