mirror of
https://github.com/hathach/tinyusb.git
synced 2026-08-18 11:02:16 +00:00
4b1c8d16f7
Documentation tooling:
- Add the `build-doc` skill and `tools/build_doc.py` wrapper for local
Sphinx builds (clean / -W / open).
- Enable Markdown (MyST) in conf.py and auto-collect
examples/{device,host,dual}/*/README.md into a 3-level Examples nav
(Examples > Device/Host/Dual > example), noting each page's source
location and normalizing headings to a single H1.
- Remove the stale `.claude/commands/build-doc.md`; point the AGENTS.md
Documentation section at the skill.
Example docs:
- Add a README.md for every device/host/dual example: what it does, USB
interface table, notable tusb_config.h settings, generic CMake + Make
build steps, and how to try it.
- Fold each *_freertos variant into its base README, noting the FreeRTOS
source path and any RTOS-specific behavior.
Generated docs/examples/ output is git-ignored. Builds clean with
`sphinx-build -W`.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Host: HID Controller
A USB host example that reads a USB game controller / gamepad (a HID device) and prints its inputs over the debug UART.
What it does
- Enumerates HID devices (
CFG_TUH_HID) and, on mount, prints the device's VID/PID. - Decodes reports from explicitly supported controllers — Sony DualShock 4 and a few compatible PS4 pads (Hori FC4, Hori PS4 Mini, ASW GG xrd) — printing the joystick axes (x, y, z, rz), D-pad direction, and pressed buttons (Square/Cross/Circle/Triangle, L1/R1/L2/R2, Share/Option/L3/R3, PS, touchpad click). Output is only printed when the report changes meaningfully.
- Sends a periodic rumble output report back to the DualShock 4, with the motor intensities driven by the L2/R2 analog triggers.
- Blinks the board LED once per second.
Note: events are only shown for the explicitly supported controllers above; other HID devices enumerate but their reports are not decoded.
Requirements
The board must support USB host mode (provide VBUS to the connected device); some boards need an external USB-A port / host adapter.
Configuration
Notable tusb_config.h settings:
#define CFG_TUH_ENABLED 1
#define CFG_TUH_HUB 0
#define CFG_TUH_HID (3*CFG_TUH_DEVICE_MAX)
#define CFG_TUH_DEVICE_MAX (3*CFG_TUH_HUB + 1)
#define CFG_TUH_HID_EP_BUFSIZE 64
Building
CMake:
mkdir build && cd build
cmake -DBOARD=raspberry_pi_pico ..
cmake --build .
Make:
make BOARD=raspberry_pi_pico all
How to use
Plug a supported USB game controller (e.g. a Sony DualShock 4) into the board's USB host port. Move the sticks and press buttons — the changes are printed on the debug UART, and squeezing the L2/R2 triggers makes the controller rumble.